LED motion sensor safety light solar light outdoor wall lamp excess waterproof and energy saving floodlight
LED: wafer 30LM SMD2835LED *46pcs
Luminous flux: 800lm
Solar panel: 5.0V 2.5w
Lithium iron phosphate battery: 3.2V/3000mAh
Working current: 1600mA
Maximum output power: 6.0W
Lighting mode: 4 lighting modes are adjustable
Charging time: 8 hours in summer sunshine
Lighting time: induction lighting for 15 seconds can be lit more than 500 times (at full power)
If the induction delay time is not detected again, the timing will start again.
Lighting range: 30 square meters
Waterproof rating: IP65
Installation method: wall-mounted
1*Solar light, mounting accessories
Four modes of work?
Keep the solar panels tightly covered or solar panels down
Put it on the desktop and hold the key for 5 seconds to start Lamp circuit work
1. Microlight + induction mode
When someone comes, the light becomes strong;When people leave, The lights dimmer.(recommended preferred mode)
2. Induction mode
When someone comes, the light becomes strong;When people leave, The lights went out.(the lack of light)
3. Changliang mode
It's dark automatically lights up, and it's full of electricity to light up till dawn.
4. Emergency lighting mode
Used for emergency lighting, such as blackouts and night activities.
The emergency light mode is 30 minutes at a time, and then the lights will be switched off
The starter will light up the solar panel to restart.
5. Turn it off
?When using for the first time, please ensure that the sun is shining and the sunshine is sufficient for 8 hours.
?Please press the switch button to turn on the light before installation.
? In winter, due to lack of light, solar lights cannot be